X1C all of the four AMS slots blinking "red" no Print possible

Ams Blinking Red. X1C all of the four AMS slots blinking "red" no Print possible The bed levelling gets executed and the filament gets loaded from the AMS I have broken down this unit, cleaned it out, replaced the first stage feeder with a brand new spare I have for justInCase and internal PTFE.

I've run through ALL Bambu's troubleshooting steps, and the only thing that it could be is a faulty AMS My dear Bambu friends, hi everyone! I greet you from The Netherlands! I hope someone can help me with the following AMS problem (I already made a support ticket to)

😮 How to fix AMS red flashing light 🚨 bambu bambulab 3dprinting

The LED lights in the AMS with occupied slots are white and the. I've been fighting two flashing lights, which indicates a filament issue outside the AMS The problem usually occurred after a filament change, but sometimes it also happened during printing with the same filament, although in that case, it was just a static red LED

Is Your Smoke Alarm Test Blinking Red? Smoke Alarm Blinking Red. During regular use of AMS, you can assess its proper functioning by observing the status of the LED lights on the first-stage feeders If you encounter either of the above conditions, you can troubleshoot using the methods in this article

All four AMS LEDs flashing red. Communication error with AMS Bambu. All spool lights on my AMS started blinking red during a print, but my printer is still printing There is NO filament anywhere outside of the AMS, nozzle is clean